User Manual

10 806143 - CW ChillTap UCCT 10.18 v1.03
Operation & Maintenance
Operation
To dispense chilled, filtered water, rotate the lever on the right hand
side of the carafe tap to a horizontal position. The lever will spring
back when released.
ChillTap Extra: Chilled still filtered water is dispensed using the
lever on the right hand side of the carafe tap (blue marking).
Ambient filtered water is dispensed using the lever on the left hand
side of the carafe tap (white marking).
The levers will spring back to the upright position and water flow
will stop, when released.
Chilled filtered
water (blue)
(ChillTap Extra)
Ambient water
(white)
ROTATE
Water Filter
For safe operation, the filter cartridge should be replaced every
6-12 months, or earlier if you notice a persistent reduction in water
pressure from the appliance or an unpleasant taste or odour in the
water. To replace the water filter cartridge:
1. Turn off the water and power supply to the unit.
2. Turn on the chilled water lever (blue marking), to release the
water pressure in the unit. Once water has stopped running
from the tap, turn off the lever.
3. Turn the filter clockwise and gently pull the cartridge down.
The cartridge should release from the filter head. Dispose of
the filter cartridge responsibly. Clean any water that has pooled
below the filter head.
4. Fit a new filter by turning filter anti-clockwise and gently
pushing up. The filter will click or lock into place.
5. Turn on the water supply to the unit.
6. Turn on the chilled water tap. Allow 7.5 litres to flow from the outlet.
7. Turn off the chilled water tap.
8. Turn on the power supply to the unit.
1. ROTATE
2. PULL DOWN
1. INSERT
2. ROTATE
REMOVE FILTER INSERT FILTER
Warning: Not changing filtration cartridges when
required may cause the water to become biologically unsafe.
If the Zip ChillTap is switched off for a long period of time
(e.g. more than a weekend), run water through the chilled water
outlet for at least 5 minutes before consumption.
Use only a Zip filter to match that used with this ChillTap (if fitted).
Replacement filter cartridges can be obtained through plumbing
suppliers or directly from Zip.
Air Inlet Screen
The Zip ChillTap air inlet screen is located on the side of the under
sink unit. The screen needs to be inspected at least quarterly,
cleaned and replaced if damaged.
Remove the screen for cleaning by sliding it forward. Rinse off any
particles with tap water, then gently dry with a cloth or towel. Slide
the screen back into place.
Note : For best performance the unit should only be operated with a
clean air inlet screen, correctly fitted in place. Maintain at least a 50
mm air gap in front of the screen at all times. Take care not to allow
cloths or other soft materials to accidentally block the air inlet.
Slide to remove