User Manual

8
Instructions for user - 9120-15002 - MCX - 801052 - March 2012 v1.01
6. Description of applicance
The Zip instantaneous water heaters are compact electronically controlled water heaters. It is intended to provide economical heating of
water for a wash basin when installed together with a sanitary water fitting. When the hot-water tap is opened, the heater switches itself
on automatically when the minimum water flow rate is exceeded and heats the water as it passes through the appliance.
There are 3 available temperature settings, 35ºC, 38ºC and 45ºC (Max).
For best performance, always fit the special flow controller included with the appliance. This controller is inserted into the outler at the
end of the tap and fits into any standard sleeve size M 22/24.
The maximum possible outlet temperature is determined by the temperature of the incoming water, the rate of flow and the heating
power of the appliance.
This appliance delivers water not exceeding 50ºC in accordance with AS3498.
7. Operation
Touch key
Three coloured LEDs
Temperature setting
The “Touch” key
allows you to select one of three preset temperatures.
Every key press sets the temperature to the next level:
35 °C >
> 38°C >
>
45°C (MAX) >
>
35°C
Pressing the key
once again, starts the cycle all over.
The currently selected temperature is indicated by one of three coloured LEDs.
Key lock and temperature lock
The currently selected temperature setting can be locked against unintended changes. Thus, the temperature cannot be changed by a
single keypress.
Activate keylock / Deactivate keylock:
Press “Touch” key (for approx. 5 seconds) until the active LED goes out, then release “Touch” key.