Product guide

40 41
Zip Econoboil
®
Wall mounted instant boiling water
3 & 5 litre
Heating element
Embedded rod type.
Boiling chamber
Twin chamber in copper.
Steam-Heat-Boost technology.
Insulation
Aluminium backed Tontine.
Thermostat
Capillary type.
Case
Corrosion resistant white enamelled steel.
Tap
Two way, chrome-plated classic, catering
style.
Approvals
WRAS, CE endorsed.
Warranty
One-year on site parts and labour. For full
details of the Zip Warranty
visit: www.zipheaters.co.uk/warranty
Installation
Install over a draining board, or work top
fitted with a drip tray. Tap spout should
be no higher than is necessary to fill large
pots. Minimum tap height above draining
board for on-wall maintenance is 200mm.
Plumbing
Designed for connection to a potable cold
water supply with a minimum pressure
of 0.7 bar. If pressure exceeds 7 bar a
pressure limiting valve must be fitted. An
isolating valve should be installed between
the mains supply and the system.
Concealed plumbing
Connect inlet and vent pipes from the rear
via 15mm capillary elbows.
Exposed plumbing
Connect inlet and vent pipes from below
directly to 15mm compression fittings.
Venting
The vent must discharge to a safe and
visible position using a tundish.
Electrical
To be wired to a double pole fused spur,
minimum break capacity of 13 amps.
Installation must comply with current IEE
regulations.
Caution
In some hard water areas where scale is an
issue we recommend the fitting of the Zip
Inline filter.
Product
Code
Case Finish
s/steel white
Capacity
litres
Delivery
cups* at any
one time
Recovery
cups*
per hour
Rating
kW
@230V
Dimensions
W x D x H
(mm)
- HS503 3.0 18 100 1.5 289 x 180 x 431
- HS505 5.0 30 140 2.4 318 x 198 x 465
Zip Econoboil the low cost boiling water solution for locations where economy is of the essence
* Standard cup size 167ml
Wall mounted instant boiling water
Wall mounted instant boiling water