Instructions / Assembly
INSTALLATION and ASSEMBLY SAFETY INSTRUCTIONS (continued)
Please Note: Observing the following statements and warnings reduces the likelihood of serious or fatal injury.
10. Now, while standing erect, test the connections by placing your full weight (as close to 250 lbs. as possible) on the
trolley at approximately the center point of the ride. If you feel any slippage you must adjust the tension again and
tighten the cable clamps further. Repeat this process until there is no slippage.
11. Obtain a secure platform to place at the starting point of the ride. Place it at the start of the ride and make sure that
it cannot tip in any direction.
12. Now test the ride. You should stop a short distance before reaching the other end. If you stop considerably short,
then you probably have too much tension in the cable and should loosen the turnbuckle slightly. If you come too
close to the ground, then you may have too little tension and should tighten the turnbuckle slightly, or you should
recheck your measurements.
Your ZL90 is now ready for use and enjoyment.
Maintenance
1. After the rst use, you may expect a small amount of stretch in the cable due to its construction.
This is normal and can be adjusted by following the installation instruction step 9.
2. Before each use, check the trolley, cable, cable sling, cable clamps and turnbuckle’s for evidence
of deterioration, excessive wear, fractures, breaks or sharp edges. Replace if necessary.
3. Check all bolt covering and sharp edges twice monthly during the usage season,
replace if necessary and check again at the beginning of each new usage season.
4. Check all nuts and bolts twice monthly during the usage season for tightness and tighten as required.
It is particularly important that this procedure be followed at the beginning of each usage season.
5. Take the ZL90 Zip Line trolley indoors when the temperature drops below freezing, 32 degrees Fahrenheit.
6. When done at prescribed intervals, these precautions will provide for long lasting and safe use of ZL90 Zip Line.
7. If you are installing ZL90 Zip Line in an area that experiences long periods of low humidity, water the trolley frequently
during these periods and replace the trolley handles if the color begins to fade.
8. Rake and check the depth of loose ll protective surfacing materials to prevent compaction and to maintain appropriate depth.
Replace as necessary. It is particularly important that this procedure be followed at the beginning and end of each usage season.
9. Owners shall be responsible for maintaining the legibility of the warning labels.
WARNING: Always check the cable before use following an electrical storm. Lightning can strike the cable and
weaken it, which could result in a fall and injury!
WARNING: Failure to carry out these checks and inspections could result in a fall and injury!
DISASSEMBLY
1. Follow the steps backwards beginning with the release of tension at the turnbuckle.
DISPOSAL
1. Disassemble and dispose of all playground equipment in such a way that no unreasonable hazards will exist at the time it is
discarded.
LIMITED WARRANTY
Zip Line Fun warrants to the rst consumer purchaser, for a period of one (1) year from the date of purchase, that the Zip Line will be free from defective
workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective product or part thereof at no charge to the
purchaser for parts or for labor.
This warranty does not apply to any product which has been damaged or defaced, which has been subject to misuse, abnormal service or handling, or which has
been altered or modied in design, construction, assembly, installation or operation.
In order to enforce the rights under this limited warranty, the purchaser should return the warranty registration card enclosed in the product package and contact
Zip Line Fun if a problem occurs. In the alternative, the purchaser should have available and submit a proof of purchase to Zip Line Fun.
This limited warranty described above is in addition to whatever implied warranties may be granted to purchasers by law.
The warranties described above shall be the sole and exclusive remedy available to the purchaser.