Instructions / Assembly

A. Attachtherstclamp(atthehigh

end) so the U-bolt is one clamp

base width from the dead end

of the wire rope.

B. Tighten U-bolt nuts evenly on

rstclamp.Attachsecond

clamp no closer to the

tree/upright than 1½ times

the diameter of the tree/upright.

C. Attach the third clamp evenly

betweenthersttwoclamps.

Now tighten all nuts evenly.

Re-tighten all nuts after

the rst ride.

DISTANCE NOTE: Do not place the

rstcableclampclosesttothetree/upright

any nearer than 1½ times the diameter of the

tree/upright.

INSTALLATION and ASSEMBLY SAFETY INSTRUCTIONS (continued)

Please Note: Observing the following statements and warnings reduces the likelihood of serious or fatal injury.

3. Using three (3) of the cable clamps (B) provided with lockwashers and nuts, secure the cable at the starting point

(high end) as illustrated below. Tighten the nuts carefully with a socket wrench (5/16 or 8mm) and push the tread

caps (F) over the exposed threads.