MSDS

Page 5 / 11
RD-0042 - Zip-A-Way Removable Sealant – Solvent Based - Clear
Revision Date: 25-Sep-2013
Precautions for safe handling
Advice on Safe Handling Handle in accordance with good industrial hygiene and safety practice. Obtain special
instructions before use. Do not handle until all safety precautions have been read and
understood. Use personal protection recommended in Section 8. Use only with adequate
ventilation. Do not breathe vapors. Wear eye/face protection. Wash thoroughly with soap
and water after handling. Avoid contact with skin, eyes or clothing. While handling product
keep out of reach of children and pets. Do not eat or drink while handling this material. See
section 6 of this SDS for clean up instructions. Keep away from heat/sparks/open
flames/hot surfaces. — No smoking. Ground/bond container and receiving equipment. Use
spark-proof tools and explosion-proof equipment. Take precautionary measures against
static discharges. Keep cool.
Conditions for safe storage, including any incompatibilities
Storage Conditions Keep container tightly closed and store in a cool, dry and well-ventilated place. Store away
from incompatible materials. Protect from direct sunlight.
Incompatible Materials Strong oxidizing agents, Caustics.
Exposure Guidelines Exposure guidelines / protective equipment are for routine handling and accidental spills
Chemical Name
ACGIH TLV
OSHA PEL
NIOSH IDLH
Toluene
108-88-3
TWA: 20 ppm
TWA: 200 ppm
(vacated) TWA: 100 ppm
(vacated) TWA: 375 mg/m
3
(vacated) STEL: 150 ppm
(vacated) STEL: 560 mg/m
3
Ceiling: 300 ppm
IDLH: 500 ppm
TWA: 100 ppm
TWA: 375 mg/m
3
STEL: 150 ppm
STEL: 560 mg/m
3
Appropriate engineering controls
Engineering Controls Provide sufficient general &/or local exhaust ventilation to maintain exposure below
recommended exposure limits. Vapors are heavier than air & may spread along floors.
Provide fresh air entry during application & curing. Eye wash fountain should be located in
immediate work area.
Individual protection measures, such as personal protective equipment
Eye/Face Protection Use approved safety goggles or safety glasses. If necessary, refer to appropriate
regulations & standards.
Skin and Body Protection Skin: Wear chemical impervious gloves (eg: Nitrile or Neoprene). Use triple gloves for spill
response. If necessary, refer to appropriate regulations & standards.
Body: Use protection appropriate for task (eg: lab coat, coveralls, Tyvek suit). If necessary,
refer to OSHA Technical Manual (Sec. VII: Personal Protective Equipment)or appropriate
Standards of Canada. Use foot protection, as described in appropriate regulations &
standards.
Respiratory Protection If watering of eyes experienced, headache or dizziness or if used in workplace & air
monitoring indicates vapor levels above exposure limits, use NIOSH approved respiratory
protection in accordance w/ Federal, State & Local requirements. Consult safety equipment
supplier & OSHA Regulation 29 CFR 1910.134 for respirator requirements.
General Hygiene Considerations Handle in accordance with good industrial hygiene and safety practice. Remove & wash
contaminated clothing before reuse. Wash hands before breaks & @ end of workday.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
7. HANDLING AND STORAGE