User's Manual

2.3.2 Rear Panel

The figure below shows the rear panel of this router.

DC IN

The Power socket is where you will connect the power adapter.

WAN

This port is where you will connect with the cable to access Internet.

1/2/3/4 LAN

This port connects the router to local PC.

RST/WPS

Button

The button is on the opposite of the rear panel. Press for about 2~3 seconds,

the system LED indicator keep solid light, it means WPS working, while press

for about 10 seconds, all LEDs blinks quickly, the device will restore to factory

default settings.

3. HARDWARE INSTALLATION

3.1 Hardware Installation

For those computers you wish to connect with Internet by this router, each of the computers

must be properly connected with the router through provided UTP LAN Cables.

1. Connect the provided UTP LAN cable to one of the router’s LAN port.

2. Connect the other end of the UTP LAN cable to your computer’s LAN port.

3. Connect the second UTP LAN cable to router’s WAN port.

4. Connect the other end of the UTP LAN cable to ADSL or Modem port.

5. Plug the Power Adapter into the router and then into an outlet.

6. Turn on your computer.

7. Check and confirm that the Power & LAN LED on the router are ON.

3.2 Check the Installation

The control LEDs of the router are clearly visible and the status of the network link can be

seen instantly:

1. With the power source on, once the device is connected to the broadband modem, the

Power, WPS, LAN, WLAN and WAN port LEDs of the WLAN Router will light up indicating

a normal status.

2. When the WAN Port is connected to Internet successfully, the WAN LED will light up.

3. When the LAN Port is connected to the computer system, the LAN LED will light up.