User`s guide

CameraMate Hi-Speed Digital Media Reader/Writer

Hardware Installation on a Macintosh

After you install the Hi-Speed Digital Media Reader/Writer software (For

Macintosh 9.x only), you can install the hardware as follows. For Macintosh 10.x

proceed to the steps below.

You can connect your Hi-Speed Digital Media Reader/Writer to computers with

USB 1.1 or USB 2.0 ports.

Connecting to a Macintosh USB Port

Connect the USB connector on the Reader/Writer to the USB port on your

Macintosh. You can connect the reader directly into the computer or use the

optional extension cable as shown in the picture below.

Note: Be sure the cable is properly aligned, and do not force the connection.

USB Cable

Connecting to a USB Hub

1. Connect the USB hub (purchased separately) to your Macintosh USB port.

2. Connect the USB connector of the reader/writer to a port on the USB hub.

Note: Be sure the cable ends are properly aligned before connecting and do not

force the connection.

USB Port