User's Manual

Safety and Regulatory Information

Safety Information

The following safety warnings and cautions are listed to prevent damage to equipment or property and

prevent any risk of personal injury.

RF Exposure

Warning: This equipment complies with European, FCC and Canadian radiation exposure limits

set forth for an occupational/ controlled environment. The Remote Unit should be operated with

a minimum distance of 20cm (8 in) between antenna and your body

Installation

Caution: Incorrect installation, operation, and use of this equipment may cause failure to

product and could cause accidents which may harm personnel.

Caution: Optical Module must ONLY be installed on the front panel of a Primary Hub or the

unit

will not function as expected.

Warning: The Remote Unit should be installed in Restricted Access Locations only

where the maximum ambient operating temperature is 50degC. If the Remote Unit is

installed in an Operator Access Area, then the maximum ambient operating

temperature must be de-rated to 45degC.

Warning: This is NOT a CONSUMER device. It is designed for installation by an

installer approved by an ISED licensee (Innovation, Science and Economic

Development Canada). You MUST have an ISED LICENCE or the express consent of

an ISED licensee to operate this device.

Signal and Input Power

Warning: If the service module is connected directly to the output of a BTS or any RF

input source, maximum power delivered to a service module must not exceed 15dBm

(damage level is 22dBm). Use additional equipment to attenuate the power.

Caution: The input power to the Zinwave Remote Unit should not exceed -10dBm. Power

levels greater than +10dBm will damage the unit

Caution: The total broadband composite output power of the 308-0007-1 Remote Unit is

limited to +24 dBm in USA Caution: The total broadband composite output power of the

308-0007-2 Remote Unit is limited to +27 dBm in USA

Contact Zinwave for the maximum output power in other regions.

Caution: Alarm Relays on the Hubs and Remote Unit are intended for low voltage/current

signaling only. Maximum operating voltage 50V, maximum operating current 1A.

CAUTION :