User's Manual

Uniwave Initial System Setup

User Manual

have such a device set this field to 0.0.0.0.

10.6.3 SNMP Settings

Trap IP Address

The network address to which traps are to be sent. This would usually be the network management computer.

Setting this field to 0.0.0.0 disables traps.

Trap Port

The UDP port number to which traps are sent. For most systems this will be 162.

Trap Type

SNMP traps can be configured to use either the “Trap” or “Inform” transport mechanism. “Trap” is more widely

supported, but “Inform” provides additional reliability.

RO Community

SNMP Read-Only Community string is the password that must be used by an SNMP Manager to gain SNMP

GET Request access to the Hub. This should be changed from the default value of "public" if SNMP access is to

be secured.

RW Community

SNMP Read-Write Community string is the password that must be used by an SNMP Manager to gain SNMP

SET Request access to the Hub. This should be changed from the default value of "private" if SNMP access is to

be secured.

10.6.4 User Interface Settings

Connection Encryption (SSL)

Connection encryption for the browser can be set to enabled (https) or disabled (http).

This determines whether browser connections must use an encrypted (https) or unencrypted (http) connection.

Note: On changing this setting, the user will be required to log back into the GUI.

10.6.5 Date & Time

The date and time used by the Hub can be configured.

NTP Client

This enables or disables the Network Time Protocol (NTP) feature. When enabled, the Hub will fetch the current

time from a time server on the local network or the internet.

If NTP is enabled, the Time and Date settings will be disabled.

NTP Server