User's Manual

DOUBLE POLE/NEUTRAL FUSING

The Power Supply Module in the Primary Hub 308-0001, and in the Secondary

Hub 308-0004 has multiple sources and may include a fuse in the Neutral AC

connection. Disconnect the AC mains supply to de-energize the phase conductors.

After operation of the fuse, parts of the equipment that remain energized might

represent a hazard during servicing.

Fiber Considerations

Caution: Avoid dust ingress to fiber connectors by mounting the Remote Unit with the fiber

connector facing downwards, or by leaving the dust-caps in place until the fiber is connected.

Caution: Connector types must match (i.e. SC-APC to SC-APC). Otherwise, there will be an

air gap between the connector faces that will create high back reflection and high optical loss.

Caution: Zinwave hardware ONLY supports SINGLE Mode Fiber.

Caution: Fiber handling procedures should be carefully observed so as not to damage or

introduce dirt to fiber interfaces during installation.

Caution: Observe safety precautions when working with fiber cables and devices.