Technical Specifications

TECHNICAL DATA OKN-01
OKON S-20 WATER REPELLENT SEALER FOR DENSE CONCRETE AND MASONRY
Form: JPB-01
Rev.: 051613
2
PRODUCT APPLICATION (cont.) .
backroll remaining pools or puddles with dry-roller to
prevent excess material from drying on the surface.
Material that is not absorbed should be back rolled or
brushed out to avoid build up. A second coat may be
applied to maximize protection while the first coat is still
damp. Protect shrubbery, plants, and grass, glass, metal
and asphalt surfaces during application.
LIMITATIONS
OKON S-20 does not provide protection against
hydrostatic water pressure, efflorescence caused by
interior moisture sources, or moisture penetration through
cracks in mortar, expansion joints or junctures between
dissimilar materials. S-20 will not fill large pores, bridge
cracks, seal inaccessible areas, or compensate for
flawed construction. Do not use on glazed or sealed
surfaces. Do not tint. A mock-up should always be
performed and approved by property owner. To protect
more porous substrates when RILEM tube test standards
are required use OKON PLUGGER. Refer to Technical
Data Bulletin for detailed use instructions.
CLEAN UP
Clean hands and tools with soapy water. Clean drips, runs
and over-spray residue while still wet, using detergent and
water. S-20 will not etch common glass but spills and over
spray onto glass should be removed with a damp cloth
while wet. Dried material may require mechanical abrasion
to remove. Clean application and spray equipment with
detergent and water immediately following use.
5-YEAR WATER REPELLENCY WARRANTY
Properly specified and applied applications of OKON S-20
may qualify for a 5-Year Warranty (Completion of a project
verification form is required to qualify). Two coats are
generally required to achieve this performance standard.
Not all substrates can achieve this standard regardless of
the number of coats applied. Request OKON Warranty
procedure for details.
WARRANTY
The manufacturer will replace this product if, within 60
days of the date of purchase, it is shown to be defective
when used as directed. THE MANUFACTURER’S
LIABILITY UNDER ANY WARRANTY, WHETHER
EXPRESSED OR IMPLIED, IS LIMITED IN DURATION
TO 60 DAYS AND IS LIMITED SOLELY TO
REPLACEMENT OF THE PRODUCT AND DOES NOT
INCLUDE LABOR OR OTHER CONSEQUENTIAL
DAMAGES. Some states do not allow limitation on
how long an implied warranty lasts or do not allow the
exclusion or limitation of incidental or consequential
damages. So the above limitation or exclusion may not
apply to you. This warranty gives you specific legal rights,
PRODUCT APPLICATION (cont.) .
and you may also have other rights which vary from state
to state.
KEEP FROM FREEZING
WARNING! KEEP OUT OF REACH OF CHILDREN