Technical Specifications
WARNING:
Flammable liquid and vapor. Contains ethanol. Keep away from heat, sparks, and open flame. Use with adequate ventilation. Do
not smoke while using. Do not get in eyes. In case of eye contact, flush eyes with plenty of water for at least 15 minutes. Do not
breathe vapors. If you experience
difficulty in breathing, eye watering, headache or dizziness, increase fresh air or leave the area to obtain fresh air. If symptoms persist
get medical attention. If spraying use explosion-proof equipment and wear a NIOSH-approved respirator. Do not take internally. If
swallowed, contact a physician or Poison Control Center. Avoid skin contact. Keep container closed when not in use. KEEP OUT OF
REACH OF CHILDREN.
Warranty – B-I-N is guaranteed to perform as indicated when applied according to label directions to a properly prepared surface.
Directions are as complete as possible but cannot encompass all conditions, applications, and/or surfaces beyond manufacturer’s
control. The contents of the container are warranted to be free from any other defect for 2 years from the date of manufacture. All
warrantees and guarantees are limited to refund or replacement of product used with proof of purchase. No other warranty or
guarantee is expressed or implied.
Typical Physical Properties
Percent Solids, Weight:
Percent Solids, Volume:
Density
:
Viscosity
Range:
Theoretical Spread
Rate
@
1 mill
DFT:
Flame Spread
(ASTM-84-
97A):
Smoke
Contrib.
(ASTM-84-97A):
Flash Point
(ASTM
D3278):
VOC:
MPI
Certified:
51%
29%
9.8 lb. (4.4 kg)/gal
53 – 65 KU
464 sq. ft gal
0, Class 1
5, Class 1
54
o
F (12
o
C)
Max VOC 550 g/l
#36 and 46
Dry Time @75° F / 50%
RH:
Stain Sealing @ 75° F/ 50%
RH:
Adhesion Cure @ 75° F/50%
RH:
Cured Gloss @
60°:
Cured Enamel
Holdout:
Freeze/Thaw
Stable:
Shelf
Life:
Storage/Handling:
464 sq. ft gal
Touch: 20 min
Recoat: 45 min
45 min
1 – 3 days
5 – 10 % (flat)
98% gloss maintained
Yes
36 mo @ 75
o
F (24
o
C)
Store indoors
40° - 80° F
(4° - 27°C)
Disposal – Dispose of unused or unwanted product in accordance with local laws regulating solvent-based coatings.
Limitations – Not recommended for whole surface exterior application or for application to floors or decks or surfaces
subject to immersion or prolonged contact with water. These limitations are not to be construed as all-inclusive.