SDS
Date Printed: 8/3/2015
Hydrous Magnesium Silicate
2.5-10
No Information
No Information
14807-96-6
2-Propanol
1.0-2.5
GHS02-GHS07
H225-319-332-336
67-63-0
Amorphous Silica
0.1-1.0
GHS06
H331
7631-86-9
Sulfuric Acid
0.1-1.0
GHS05-GHS06
H314-330
7664-93-9
Crystalline Silica / Quartz
0.1-1.0
GHS07
H302
14808-60-7
4. First-aid Measures
FIRST AID - EYE CONTACT: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open. Get medical
attention. Do NOT allow rubbing of eyes or keeping eyes closed.
FIRST AID - SKIN CONTACT: Wash skin with soap and water. Remove contaminated clothing. Get medical attention if irritation
develops or persists.
FIRST AID - INHALATION: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get
immediate medical attention. Do NOT use mouth-to-mouth resuscitation. If you experience difficulty in breathing, leave the area to
obtain fresh air. If continued difficulty is experienced, get medical assistance immediately.
FIRST AID - INGESTION: Aspiration hazard: Do not induce vomiting or give anything by mouth because this material can enter the
lungs and cause severe lung damage. Get immediate medical attention. If swallowed, get medical attention.
5. Fire-fighting Measures
EXTINGUISHING MEDIA: Alcohol Film Forming Foam, Carbon Dioxide, Dry Chemical, Dry Sand, Water Fog
UNUSUAL FIRE AND EXPLOSION HAZARDS: Closed containers may explode when exposed to extreme heat due to buildup of
steam. Vapors may form explosive mixtures with air. Vapors can travel to a source of ignition and flash back. Keep containers tightly
closed. Isolate from heat, electrical equipment, sparks and open flame. No unusual fire or explosion hazards noted.
SPECIAL FIREFIGHTING PROCEDURES: Water may be used to cool closed containers to prevent pressure buildup and possible
autoignition or explosion. Evacuate area and fight fire from a safe distance. Use water spray to keep fire-exposed containers cool.
Containers may explode when heated.
6. Accidental Release Measures
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Contain spilled liquid with sand or earth. DO NOT use
combustible materials such as sawdust. Eliminate all ignition sources; use explosion-proof equipment. Place material in a container
and dispose of according to local, provincial, state and federal regulations. Remove all sources of ignition, ventilate area and remove
with inert absorbent and non-sparking tools. Dispose of according to local, state (provincial) and federal regulations. Do not
incinerate closed containers. Ventilate area, isolate spilled material, and remove with inert absorbent. Dispose of contaminated
absorbent, container, and unused contents in accordance with local, state, and federal regulations.
7. Handling and Storage
HANDLING: Wash thoroughly after handling. Wash hands before eating. Remove contaminated clothing and launder before reuse.
Use only with adequate ventilation. Follow all MSDS/label precautions even after container is emptied because it may retain product
residues. Avoid breathing fumes, vapors, or mist. Avoid contact with eyes, skin and clothing.
STORAGE: Store in a dry, well ventilated place. Keep container tightly closed when not in use. Keep containers tightly closed.
Isolate from heat, electrical equipment, sparks and open flame. Do not store above 120 ° F. Store large quantities in buildings
designed and protected for storage of NFPA Class II combustible liquids. Keep away from heat, sparks, flame and sources of
ignition. Keep container closed when not in use. Avoid excess heat. Product should be stored in tightly sealed containers and
protected from heat, moisture, and foreign materials.
8. Exposure Controls/Personal Protection
Chemical Name CAS-No.
Weight %
Less Than
ACGIH TLV-
TWA
ACGIH TLV-
STEL
OSHA PEL-TWA
OSHA PEL-
CEILING
Ethanol 64-17-5 45.0 N.E. 1000 ppm 1000 ppm N.E.
Titanium Dioxide 13463-67-7 15.0 10 mg/m3 N.E. 15 mg/m3 N.E.
Hydrous Magnesium Silicate 14807-96-6 10.0 2 mg/m3 N.E. N.E. N.E.
2-Propanol 67-63-0 5.0 200 ppm 400 ppm 400 ppm N.E.
Amorphous Silica 7631-86-9 1.0 N.E. N.E. N.E. N.E.
Sulfuric Acid 7664-93-9 1.0 0.2 mg/m3 N.E. 1 mg/m3 N.E.
Page 2 / 5