Technical Specifications

TECHNICAL DATA
FP2-02
ZINSSER
®
FASTPRIME
™
OIL-BASE
INTERIOR PRIMER-SEALER
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 877∙385∙8155
www.rustoleum.com/zinsser
Form: ARJ-2023
Rev.: 032320
PHYSICAL PROPERTIES
FASTPRIME OIL-BASE INTERIOR PRIMER-SEALER
Resin Type
Modified Alkyd
Pigment Type
Titanium Dioxide
Solvents
Aromatic Hydrocarbons
Weight
Per Gallon
12.9 lbs.
Per Liter
1.55 kg
Solids
By Weight
77.5%
By Volume
56.3%
Volatile Organic Compounds
325 g/l
Recommended Dry Film
Thickness (DFT) per Coat
1.5-2.5 mils
(37.5-62.5µ)
Wet Film to Achieve DFT
(Unthinned material)
2.5-4.5 mils
(62.5-112.5µ)
Practical Coverage at Recommended DFT
(assume 15% material loss)
Approximately 400 sq.ft./gal. (9.8 m
2
/l)
depending on application method and surface porosity
Dry Times at 70-80°F
(21-27ºC) and 50%
Relative Humidity
Touch
40 minutes
Sand or Recoat
2 hours
Shelf Life
5 years
Flash Point
104ºF (40ºC)
Storage
Store indoors at 40-90°F (4-32°C)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.