Technical Specifications

FIRST AID
Warning! Do not get in eyes. In case of eye contact, flush eyes with plenty of water for at least 15 minutes. Wear eye
and skin protection. Avoid contact with skin and clothing. Wash thoroughly after handling. Do not swallow. If swallowed
call a physician or Poison Control Center. Use only with adequate ventilation. Do not breathe vapors or spray mist. Ensure
good cross ventilation during application and drying. If you experience difficulty in breathing, eye watering, headache, or
dizziness, increase fresh air; wear an appropriate, properly fitted (NIOSH approved) respirator; or leave the area to obtain
fresh air. Keep container closed when not in use.
WARRANTY
*10 Year Durability Guarantee – Limited Warranty – WATERTITE Flexible Primer & Finish is guaranteed for ten years
from the date of purchase to provide protection from exterior moisture when two coats are applied according to label
directions except when leaks are due to settlement cracks or surface deterioration. In addition, the dried paint film is
guaranteed for 10 years to resist fading, peeling and blistering. The contents are warranted to be free from defects for
two years from date of manufacture. This limited warranty is limited to replacement or refunded value of product actually
used when supported by proof of purchase. Label directions are as complete as possible but can not encompass all
surfaces, conditions, applications and/or surfaces beyond Zinsser’s control. If you have a question, check with your dealer
or call Rust-Oleum Corporation.
LIMITATIONS: Does not hold back hydrostatic water pressure. Not recommended for use in swimming pools or use in
contact with potable water. Not recommended for use on horizontal surfaces (i.e. subfloors). Do not use on glazed or
non-porous surfaces.
Technical Assistance - Available through local authorized Zinsser dealers. For the dealer nearest you call 847-367-7700
or visit our website at www.zinsser.com.
Keep out of reach of children
This product meets Master Painters Institute
(MPI) specification #3 and #4 qualifies for LEED
EQ Credit 4.2 (10/2010).