Technical Specifications
TECHNICAL DATA
WRT-04
ZINSSER
®
WATERTITE
®
FLEXIBLE PRIMER & FINISH
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 888∙855∙1774
www.rustoleum.com
Form: GDH-54
Rev.: 031320
PHYSICAL PROPERTIES
WHITE TINT BASE
DEEP TINT BASE
Resin Type
Acrylic Latex
Acrylic Latex
Pigment Type
Titanium Dioxide, Aluminum Silicate
Titanium Dioxide, Aluminum Silicate
Solvents
Glycol Ethers, Texanol, Water
Glycol Ethers, Texanol, Water
Weight
Per Gallon
12.7 lbs.
12.1 lbs.
Per Liter
1.52 kg
1.45 kg
Solids
By Weight
67.8%
64.9%
By Volume
51.1%
49.0%
Volatile Organic Compounds
<50 g/l (0.42 lbs./gal.)
<50 g/l (0.42 lbs./gal.)
Recommended Dry Film
Thickness (DFT) per Coat
5.0-6.0 mils (125-150µ) per coat
5.0-6.0 mils (125-150µ) per coat
Wet Film to Achieve DFT
(Unthinned material)
10.0-12.0 mils (250-300µ) per coat
10.0-12.0 mils (250-300µ) per coat
Theoretical Coverage at
1 mil DFT (25µ)
820 sq.ft./gal.
(20.2 m
2
/l)
787 sq.ft./gal.
(19.4 m
2
/l)
Practical Coverage at Recommended
DFT (assume 15% material loss)
100-135 sq.ft./gal.
(2.46-3.32 m
2
/l)
Coverage may change depending on
porosity and application method.
100-135 sq.ft./gal.
(2.46-3.32 m
2
/l)
Coverage may change depending on
porosity and application method
Dry Times at 70-80°F
(21-27ºC) and 50%
Relative Humidity
Touch
4 hours
4 hours
Handle
8 hours
8 hours
Recoat
2 hours
2 hours
Full Cure
7 days
7 days
Shelf Life
3 years
3 years
Flash Point
>200ºF (93ºC)
>200ºF (93ºC)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.