MSDS

ManualsBrandsZinsser ManualsPaint1/2-pt. Ready Patch Lite Spackling and Patching Compound (12-Pack)

Material Safety Data Sheet

N/A: Not Applicable N/D: Not Determined N/E: Not Established N/R: Not Required Est.: Estimated

MSDS Code: Ready Patch Lite (4-10-9).doc Page 1 of 6 pages.

Section 1 General Information

Manufacturer:

Rust-Oleum Corporation

11 Hawthorn Parkway

Vernon Hills, IL 60061

24 Hour Assistance: 1-847-367-7700

www.rustoleum.com Date: April 10, 2009

Product Name: Zinsser Ready Patch Lite

Codes: 04301 04304 04308 04309

Section 2 Hazardous Ingredients

OSHA ACGIH

Hazardous Component CAS# PEL TLV OTHER**

Borosilicate Glass 65997-17-3 N/E N/E 10 mg/m

Ethylene Glycol 107-21-1 N/E 100 mg/m

* Total Dust C Ceiling limit

Section 3 Hazard Identification

Emergency Overview: This material is lightweight patching compound. It is a viscous

white paste with a flash point above 200 °F.

Primary Routes of Exposure:

Eye Contact

Potential Acute Health Effects:

Eye: May cause eye irritation.

Skin: May cause skin irritation. However, absorption through the skin contact is not considered

a significant route of exposure during intended use.

Ingestion: Ingestion is not considered a significant route of exposure during intended use.

Inhalation: May cause respiratory irritation from dust generated by sanding. If

signs/symptoms occur, remove person to fresh air. If signs/symptoms persist, consult a physician.

Summary of content (6 pages)

PAGE 1
Material Safety Data Sheet Section 1 General Information Manufacturer: Rust-Oleum Corporation 11 Hawthorn Parkway Vernon Hills, IL 60061 24 Hour Assistance: 1-847-367-7700 www.rustoleum.
PAGE 2
Potential Chronic Health Effects: None Known. Signs and Symptoms: N/A (See also Sections 4, 8, and 11for related information) Section 4 First Aid Measures Eye contact: Flush eyes with water for 15 minutes. Skin contact: Wash with soap and water. Get medical attention if symptoms occur. Ingestion: If swallowed, call a physician or poison control center. Inhalation: No specific treatment is necessary since this material is not likely to be hazardous by inhalation.
PAGE 3
Section 7 Handling and Storage Handling: Avoid contact with eyes, skin, and clothing. Storage: Keep from freezing. Keep container closed when not in use. Section 8 Exposure Controls / Personal Protection Engineering Controls: If exposure conditions warrant, use mechanical local exhaust ventilation or general dilution ventilation to reduce vapor and/or dust concentrations.
PAGE 4
Stability: This material is stable. Not reactive. Hazardous Polymerization: Will not occur. Hazardous Decomposition Products: None known. Conditions to Avoid: None known. Incompatibility: None known. Section 11 Toxicological Information Chronic Health Effects: None known. Carcinocenicity: This material is not considered a carcinogen by IARC or NTP and is not regulated as a carcinogen by OSHA. Section 12 Ecological Information Chemical Fate and Effects: No data available.
PAGE 5
CERCLA: The Comprehensive Environmental Response Compensation and Liability Act of 1980 (CERCLA) requires notification to the National Response Center for releases of quantities of Hazardous Substances equal to or greater than the reportable quantities (RQs) in 40 CFR 302.4 (for CERCLA 102). Components present in this product at a level which could require reporting under the statute are: Chemical Name Ethylene Glycol CAS# 107-21-1 Maximum Concentration (Wt.
PAGE 6
N/E: Not Established N/R: Not Required STEL: Short Term Exposure Limit C: OSHA Ceiling Value PPM: Parts Per Million PPB: Parts Per Billion PEL: Permissible Exposure Limit TLV: Threshold Limit Value TWA: Time Weighted Average mg/m3: Milligrams per cubic Meter mppcf: Million particles per cubic foot of air. ACGIH: American Conference of Governmental Industrial Hygienists OSHA: Occupational Safety and Health Administration (US Dept.