Technical Specifications

Bull Eye Odorless TDB with MPI (10-15-10)215
Cleanup – Clean up spills and drips immediately with mineral spirits. Rinse application tools in mineral spirits immediately after
use. Follow manufacturer’s instructions to clean spray equipment.
Disposal – Dispose of unused or unwanted product in accordance with local laws regulating solvent-based coatings.
Surface Preparation
Surfaces should be clean, dry, sound and free of dust, dirt, excessive chalky material, grime, grease, oil, wax, mildew, wallpaper
adhesive or any contamination that may interfere with adhesion. If unsure, always wash surface with a household ammonia and
water solution, appropriate cleaning solution, or solvent (Do not use TSP as a cleaner). Remove any unsoundly adhered coatings.
Sand any remaining paint film edges smooth with the surface. Attempt to remove existing stains by washing, sanding, scraping,
etc. Remove interior mildew with an interior mildew cleaner. Countersink exposed nail heads, spot-prime and fill with Zinsser
Ready Patch
®
spackling compound. Remove rust and wipe metal with a cloth dampened in alcohol. Clean new galvanized metal
with paint thinner with a final rinse in vinegar to remove oils. Spot prime knots and sap streaks with Zinsser B-I-N
®
Primer-Sealer
before priming full surface with ODORLESS.
WARNING! If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN
CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH-Approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and wet mop.
Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-
LEAD or log on to www.epa.gov/lead.
Limitations
ODORLESS is not intended for exterior surfaces or for application to floors, decks, roof surfaces or any surface subject to
immersion or prolonged contact with water. These limitations are not to be construed as all inclusive.
Precautions
Keep away from children. Do not take internally. Avoid inhalation of spray or prolonged skin contact. To prevent product from
skinning over close container after each use. Keep lid tightly closed during storage. Protect from freezing. If contents freeze, thaw
to room temperature before using.
Warranty – ODORLESS is guaranteed to perform as indicated when applied according to label directions to a properly
prepared surface. Directions are as complete as possible but cannot encompass all conditions, applications, and/or surfaces beyond
manufacturer’s control. The contents of the container are warranted to be free from any other defect for 2 years from the date of
manufacture. All warrantees and guarantees are limited to refund or replacement of product used with proof of purchase. No other
warranty or guarantee is expressed or implied.
Application Data
Brush, roller or pad Natural bristle or lambskin
Airless Spray .017” tip @ 2200-2800 psi
Minimum pump size: ¾ G.P.M
Practical Spread Rate 350 – 450 sq. ft. per gallon
Application Conditions
Temperature Range: 40
o
– 90
o
F
Relative Humidity: 10% - 85%
Substrate Moisture: 12% max moisture content
Dry Time (75
o
F / 50% RH)
To Touch: 1 hr To
Recoat: 2 hr
Stain Sealing: 2 hrs
Full Scrape Cure: 7 days
Tinting Up to 2 fl oz Universal Colorant