Technical Specifications

TECHNICAL DATA
ZNR-82
ZINSSER
®
SMARCOAT ADVANCED
PAINT & PRIMER IN ONE
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 877∙385∙8155
www.rustoleum.com/zinsser
Form: ARJ-1998
Rev.: 040920
PHYSICAL PROPERTIES
SMARTCOAT ADVANCED PAINT & PRIMER IN ONE
Resin Type
Styrene Acrylic
Pigment Type
Varies by color
Solvents
Water, Glycol Ethers
Weight
Per Gallon
10.1-11.5 lbs.
Per Liter
1.2-1.4 kg
Solids
By Weight
51.2-57.8%
By Volume
40.1-42.8%
Volatile Organic Compounds
<50 g/l (lbs./gal.)
Recommended Dry Film Thickness
(DFT) per Coat
1.5-2.0 mils
(37.5-50µ)
Wet Film to Achieve DFT
(unthinned material)
2.5-5.0 mils
(62.5-175µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
8 oz. up to 25 sq. ft.
Quart up to 100 sq. ft.
Gallon up to 400 sq.ft
5 Gallon Pail up to 2,000 sq.ft.
Varies depending on porosity and type of surface
Dry Times at 77ºF
(25ºC) and 50%
Relative Humidity
Touch
1 hour
Recoat
4 hours
Full Cure
7-10 days
Shelf Life
3 years
Flash Point
>200°F (93°C)
Storage
PROTECT FROM FREEZING
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.