Use and Care Manual

TECHNICAL DATA
EXTERIOR WOOD PRIMER
Rust-Oleum Corporation Form: TDS-1371
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 070617
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
Physical Properties
EXTERIOR WOOD PRIMER
Resin Type
Water-based Acrylic
Pigment Type
Titanium Dioxide, Calcium Carbonate, Talc and Clay
Solvents
Water, Glycol Ethers
Weight
Per Gallon
10.7 lbs.
Per Liter
1.28 kg
Solids
By Weight
52.9%
By Volume
39.5%
Volatile Organic Compounds
<100 g/l
(0.83 lbs./gal.)
Recommended Dry Film Thickness
(DFT) per Coat
1-1½ mils
(25-37.5µ)
Wet Film to Achieve DFT (Unthinned
material)
2½-4 mils
(62.5-100.0µ)
Practical Coverage at Recommended
DFT (assume 15% material loss)
360-540 sq.ft./gal. (8.8-13.2 m
2
/l)
depending on application method and surface porosity
Dry Times at 70-80°F
(21-27ºC) and 50%
Relative Humidity
Touch
25 minutes
Recoat
1 hour
Shelf Life
5 years
Flash Point
>200ºF (93ºC)
Storage Conditions
40-90°F (4-32°C) Do not freeze.
Safety Information
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.