Technical Specifications

TECHNICAL DATA
WRT-11
ZINSSER
®
WATERTITE
®
CLEAR
MOLD & MILDEW PROOF FLOOR & WALL PAINT
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 888∙855∙1774
www.rustoleum.com
Form: GDH-1077
Rev.: 012821
PHYSICAL PROPERTIES
CLEAR MOLD & MILDEW-PROOF FLOOR & WALL PAINT
Resin Type
Acrylic
Pigment Type
None
Solvents
Glycol Ethers, Water
Weight
Per Gallon
8.6 lbs.
Per Liter
1.03 kg
Solids
By Weight
30.0%
By Volume
27.4%
Volatile Organic Compounds
100 g/l (0.83 lbs./gal.)
Recommended Dry Film
Thickness (DFT) Per Coat
5.0-6.0 mils
(125-150µ)
Wet Film to Achieve DFT
(unthinned material)
18.0-22.0 mils
(450-550µ)
Practical Coverage at Recommended DFT
(assumes 15% material loss)
100 sq.ft./gal. (2.5 m
2
/l)
Coverage may vary depending on porosity and application method.
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
2 hours
Recoat
2-3 hours
Light Foot Traffic
3 hours
Heavy Foot Traffic
24 hours
Shelf Life
5 years
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.