MSDS

ManualsBrandsZinsser ManualsPaint1-gal. SureGrip 120 Prepasted Activator (4-Pack)

Material Safety Data Sheet

N/A: Not Applicable N/D: Not Determined N/E: Not Established N/R: Not Required Est.: Estimated

SureGrip 120 Pre-Pasted Activator (2-22-07) Page 1 of 5 pages.

Section 1 General Information

Manufacturer:

Zinsser Company, Inc.

173 Belmont Drive

Somerset, NJ 08875

(732) 469-8100

Emergency Telephone: Chemtrec (800) 424-9300 Date: February 22, 2007

Product Name: SureGrip 120 Pre-Pasted Activator

Product Codes: 02906 02908

Section 2 Hazardous Ingredients

OSHA ACGIH

Hazardous Component CAS# PEL TLV

None. N/A N/A N/A

Section 3 Hazard Identification

Emergency Overview: This material is a clear liquid with a slight amine odor. This

material is not flammable and has a flashpoint above 200° F.

Primary Routes of Exposure:

Inhalation

Skin Contact

Potential Acute Health Effects:

Eye: May cause eye irritation.

Skin: Prolonged or repeated skin contact may cause irritation.

Ingestion: Not hazardous under intended use conditions. Although ingestion not considered

a significant route of exposure, gastrointestinal irritation and nausea may occur if swallowed.

Inhalation: Not hazardous under intended use conditions. Although inhalation is not

considered a significant route of exposure, high vapor concentrations may cause respiratory

irritation.

Potential Chronic Health Effects: None known.

(See also Sections 4, 8, and 11 for related information)

Summary of content (5 pages)

PAGE 1
Material Safety Data Sheet Section 1 General Information Manufacturer: Zinsser Company, Inc. 173 Belmont Drive Somerset, NJ 08875 (732) 469-8100 Emergency Telephone: Chemtrec (800) 424-9300 Product Name: SureGrip 120 Pre-Pasted Activator Product Codes: 02906 Section 2 Date: February 22, 2007 02908 Hazardous Ingredients Hazardous Component CAS# OSHA PEL ACGIH TLV None. N/A N/A N/A Section 3 Hazard Identification Emergency Overview: This material is a clear liquid with a slight amine odor.
PAGE 2
Section 4 First Aid Measures Eye contact: In case of eye contact, flush eyes with water for at least 15 minutes. Get medical attention if symptoms persist. Skin contact: Ingestion: In case of skin contact, wash thoroughly with soap and water. If swallowed contact a physician or poison control center. Inhalation: No specific treatment is necessary since this material is not likely to be hazardous by inhalation.
PAGE 3
Engineering Controls: If necessary, use general room dilution ventilation, process enclosures, local exhaust ventilation, or other engineering controls to control airborne levels below recommended exposure limits. Personal Protective Equipment (PPE): Eye Protection: Eye contact should be avoided. Where eye contact is likely, wear chemical splash goggles and/or full-face shield. Skin Protection: Avoid skin contact.
PAGE 4
CAS # N/A Ingredient None Section 12 NTP N/A OSHA N/A Ecological Information Chemical Fate and Effects: Section 13 IARC N/A No data available. Disposal Considerations Recommended Waste Disposal Method: This material is not considered hazardous waste under Federal Hazardous Waste Regulations (40CFR 261). However, state and local requirements for waste disposal may be more restrictive or otherwise differ from federal regulations.
PAGE 5
Chemical Name None CAS# N/A Concentration (Wt. %) N/A TSCA: The components of this mixture are listed in the Toxic Substance Control Act Inventory of Chemical Substances.