Technical Specifications

TECHNICAL DATA
ZNR -03
ZINSSER
®
DRYGARD
WATERPROOFING PAINT
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 877∙385∙8155
www.rustoleum.com/zinsser
Form: GDH-748
Rev.: 061219
PHYSICAL PROPERTIES
DRYGARD WATERPROOFING PAINT
Resin Type
Styrene-Acrylic Copolymer
Pigment Type
Titanium Dioxide
Solvents
Glycol Ethers, Water
Weight
Per Gallon
11.7 lbs.
Per Liter
1.40 kg
Solids
By Weight
62.8%
By Volume
47.8%
Volatile Organic Compounds
<100 g/l (0.83 lbs./gal.)
Recommended Dry Film
Thickness (DFT) per Coat
2.5-3.0 mils (62.5-75µ)
Two coats required
Wet Film to Achieve DFT (Unthinned material)
5-6 mils per coat
(125-150 µ)
Practical Coverage at Recommended DFT
(assume 15% material loss)
250 sq.ft./gal. (Concrete - Smooth)
200 sq.ft./gal. (Concrete – Rough)
200 sq.ft./gal. (CMU – Smooth)
200 sq.ft./gal. (CMU – Rough/Split)
250 sq.ft./gal. (Previously Coated)
Coverage may change depending on porosity and application method.
Dry Times at 70-80°F
(21-27ºC) and 50%
Relative Humidity
Touch
2 hours
Handle
4 hours
Recoat
2-3 hours
Full Cure
7 days
Shelf Life
2 years
Flash Point
>200ºF (93ºC)
Safety Information
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.