Technical Specifications

TECHNICAL DATA

BIN

ADVANCED SYNTHETIC SHELLAC PRIMER

.PRODUCT APPLICATION (cont.) .

LIMITATIONS

B-I-N Advanced is not recommended for full service use

on exterior applications, for excessively humid interior

areas or surfaces subject for immersion or prolonged

contact with water. Do not box or intermix B-I-N

Advanced with other oil-base or water-base products.

APPLICATION

Apply only when air, material, and surface temperatures

are between 50-90ºF (10-32ºC) and the relative humidity

is less than 85%. Thoroughly mix or shake to ensure any

settled pigment is re-dispersed before using. If thinning is

required, add no more than 10 ounces of water per gallon.

In most cases only one coat is necessary to prime most

surfaces. If excessive absorption occurs over very porous

substrates a second coat may be necessary. For best

results, prime entire surface before painting. Apply with a

high quality brush, 3/8” nap roller, or airless s

rayer.

manufacturer's instructions when using spray

equipment. Airless spraying - use a 0.015-0.017" tip at

1700-2200 psi. Provide adequate ventilation at all times.

DRY & RECOAT TIMES

Dry and recoat times are based on 70°F and 50% relative

humidity. Allow more time at cooler temperatures. Dries to

the touch in 25 minutes and can be recoated in 45

minutes. It is fully cured in 7 days. For knots and stain

blocking, allow 2 hours to dry. When sealing water stains,

some stain may appear in the primer film as it dries. The

stain is locked and will not bleed into the topcoat.

CLEAN-UP

Clean up spills and paint drips with warm soap and water.

Wipe up splatters before they dry. Follow the equipment

manufacturer’s directions to clean spray equipment.