Technical Specifications

TECHNICAL DATA
WRT-10
ZINSSER
®
WATERTITE
®
LX ULTRA
MOLD & MILDEW PROOF WATERPROOFING PAINT
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 888∙855∙1774
www.rustoleum.com
Form: GDH-190
Rev.: 012821
PHYSICAL PROPERTIES
WATERTITE LX ULTRA MOLD & MILDEW-PROOF WATERPROOFING
PAINT
Resin Type
Styrene Acrylic Copolymer
Pigment Type
Titanium Dioxide
Solvents
Glycol Ethers, Texanol, Water
Weight
Per Gallon
11.8 lbs.
Per Liter
1.42 kg
Solids
By Weight
62.0%
By Volume
42.3%
Volatile Organic Compounds
100 g/l (0.83 lbs./gal.)
Recommended Dry Film
Thickness (DFT) Per Coat
5.0-6.0 mils
(125-150µ)
Wet Film to Achieve DFT
(unthinned material)
12.0-14.0 mils
(300-350µ)
Theoretical Coverage at
1 mil DFT (25µ)
678 sq.ft./gal.
(16.7 m
2
/l)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
100-125 sq.ft./gal. (2.5-3.1 m
2
/l)
Coverage may change depending on porosity and application method.
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
2 hours
Recoat
2-3 hours
Full Cure
7-14 days
Shelf Life
2 years
Safety
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.