Use and Care Manual

TECHNICAL DATA
ZINSSER
®
CEILING PAINT – PAINT & PRIMER IN ONE
Rust-Oleum Corporation Form: GDH-217
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 110113
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
Physical Properties
CEILING PAINT- PAINT & PRIMER IN ONE
Resin Type
Styrene Acrylic Copolymer
Pigment Type
Titanium Dioxide, Aluminum Silicate
Solvents
Water, Glycol Ethers
Weight
Per Gallon
12.1 lbs.
Per Liter
1.45 kg
Solids
By Weight
62.1%
By Volume
42.3%
Volatile Organic Compounds
<30 g/l
Recommended Dry Film
Thickness (DFT) per Coat
1.5-2.0 mils
(25-37.5µ)
Wet Film to Achieve DFT (Unthinned
material)
3.5-5.0 mils
(87.5-125µ)
Theoretical Coverage at
1 mil DFT (25µ)
678 sq.ft./gal.
(16.7 m
2
/l)
Practical Coverage at
Recommended DFT (assume 15%
material loss)
Approximately 250-400 sq.ft./gal. (6.2-9.8 m
2
/l)
depending on application method
and surface porosity
Dry Times at 70°F
(21ºC) and 50%
Relative Humidity
Touch
1 hour
Recoat
1 hour
Shelf Life
5 years
Flash Point
>200ºF (93ºC)
Storage
Store indoors at 40-80°F (4-26°C)
Safety Information
For additional information, see MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.