Use and Care Manual

TECHNICAL DATA
B-I-N
®
2 PRIMER - STAIN BLOCKER - ODOR SEALER
Rust-Oleum Corporation Form: GDH-231
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 111413
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
2
.PRODUCT APPLICATION (cont.) .
LIMITATIONS
B-I-N 2 Primer is not recommended for full service use on
exterior applications or use on floors, or surfaces subject
for immersion or prolonged contact with water. Do not
box or intermix B-I-N 2 Primer with other oil-base or
water-based products.
APPLICATION
Apply only when air, material, and surface temperatures
are between 35-90ºF (2-32ºC) and the relative humidity is
less than 85%. The surface temperature should be 15°F (-
9°C) above the dew point for exterior applications.
Thoroughly mix or shake to ensure any settled pigment is
re-dispersed before using. Eliminate all sources of ignition.
Do not thin this product. In most cases only one coat is
necessary to prime most surfaces. If excessive absorption
occurs over very porous substrates a second coat may be
necessary. For best results, prime entire surface before
painting.
PRODUCT APPLICATION (cont.) .
Apply with a high quality natural or synthetic brush, ⅜”
nap roller, pad, conventional or airless sprayer. If
spraying, wear a NIOSH approved respirator. Follow
manufacturer's instructions when using spray equipment.
For airless spraying, use a 0.015-0.017" tip at 1500-2000
psi. Provide adequate ventilation at all times.
DRY & RECOAT TIMES
Dry and recoat times are based on 70°F and 50% relative
humidity. Allow more time at cooler temperatures. Dries to
the touch in 35 minutes and can be recoated in 2 hours.
Lower temperatures, higher humidity and the addition of
tint will prolong dry and cure time.
CLEAN-UP
Clean up spills and application equipment immediately
after use with mineral spirits. Wipe up splatter before they
dry. Follow the equipment manufacturer’s directions to
clean spray equipment.
PHYSICAL PROPERTIES
Resin Type
Medium Oil Alkyd
Solvents
Aromatic Hydrocarbons
Weight
Per Gallon
13.2 lbs.
Per Liter
1.58 kg
Solids
By Weight
79.3%
By Volume
59.3%
Volatile Organic Compounds
<340 g/l ( 2.8 lbs/gal)
Theoretical Coverage at
1 mil DFT (25µ)
951 sq. ft./gal.(23.4 m
2
/l)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
400 sq. ft./gal. (9.8 m
2
/l)
Depending on allocation method and surface porosity
Dry Times at 70°-
80°F(21°-27°C) and
50% relative humidity
Touch
35 minutes
Recoat
2 hours
Shelf Life
5 years
Safety Information
Flash Point
104°F (40°C)
See MSDS for additional information
Calculated values are shown and may vary slightly from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.