Technical Specifications

control center immediately. WARNING: This product contains a chemical known to the state of California to cause
cancer. Keep container closed when not in use. KEEP OUT OF REACH OF CHILDREN.
LIMITED WARRANTY – This product will perform as claimed if applied according to our directions. The directions apply
to most applications, but may not cover special conditions, applications, techniques and/or surfaces. If you have a
question, check with your dealer or contact Rust-Oleum Corporation, Vernon Hills, IL. Warranty is limited to replacement
or refunded value of product actually used if such product proves defective within two years of manufacture.
Typical Physical Properties
Percent Solids, Weight:
Percent Solids, Volume:
Density:
Viscosity Range:
Theoretical Spread Rate
@ 1 mill DFT:
Flash Point
(ASTM D3278):
VOC:
LEED:
77.5%
56.3%
12.9 lb. (5.8 kg)/gal
90 – 95 KU
900 sq. ft gal (84 m
2
)/gal
>104°F (>24°C)
Max VOC 350 g/l
Meets 4.2 requirements
Dry Time @75° F / 50% RH:
Stain Sealing @ 75° F/ 50% RH:
Adhesion Cure @ 75° F/50%RH:
Cured Gloss @ 60°:
Cured Enamel Holdout:
Freeze/Thaw Stable:
Shelf Life:
Storage/Handling:
3 wet mils
Touch: 35 min
Recoat: 2 hours
2 hours
7 – 10 days
5% (flat)
98% gloss maintained
Yes
60 mo @ 75
o
F (24
o
C)
Store indoors
40° - 80° F
(4° - 27°C)
Disposal – Dispose of unused or unwanted product in accordance with local laws regulating solvent-based coatings.
Limitations – Not recommended for whole surface exterior application or for application to floors or decks or surfaces
subject to immersion or prolonged contact with water. These limitations are not to be construed as all-inclusive.