Technical Specifications

Dry Time – Dries to the touch in 30 minutes. May be lightly sanded and/or topcoated after 2 hours. For two part

epoxies, wait 6 hours before topcoating. Optimal benefits of BONDZ are achieved when topcoated within 7 days when it

has reached full hardness and scrape resistance (depending on temperature, humidity and film thickness.)

Coverage – Approx. 400 sq. ft. (37m

) per gallon depending on application method and surface porosity.

Cleanup – Soap and warm water. Wipe up splatters before they dry. Follow manufacturer’s directions to clean spray

equipment.

Limitations - Not recommended for application to floors, decks, surfaces subject to immersion or prolonged contact with

water or below grade applications. Not recommended for use on polyethylene, polypropylene, Teflon or nylon.

MPI Standard - Certified by MPI to pass all requirements for MPI #17: Water-Based Bonding Primer

LEED – Meets 4.2 requirements

CAUTION! Do not get in eyes. In case of eye contact, flush eyes with plenty of water for at least 15 minutes. Do not

take internally. If swallowed call a physician or Poison Control Center. Do not breathe vapors or spray mist. Ensure

good cross ventilation during application and drying. If you experience difficulty in breathing, eye watering, headache, or

dizziness increase fresh air; wear an appropriate, properly fitted (NIOSH approved) respirator; or leave the area to obtain

fresh air. Avoid contact with skin and clothing. Wash thoroughly after handling. WARNING: This product contains a

chemical known to the state of California to cause birth defects, or other reproductive harm. Keep container closed when

not in use. KEEP OUT OF REACH OF CHILDREN.

Warranty – This product will perform as claimed if applied according to our directions. The directions apply to most

applications, but may not cover special conditions, applications, techniques and/or surfaces. If you have a question, check

with your dealer or contact Rust-Oleum Corporation, Vernon Hills, IL. Warranty is limited to replacement or refunded

value of product actually used if such product proves defective within two years of manufacture.

Typical Physical Properties:

Percent Solids, Weight: 55.1%

Percent Solids, Volume: 44.9%

Flash Point (ASTM D3278): ≥200°F

VOC: < 100 g/L

Freeze/Thaw Stable: Yes

Shelf Life: 60 months @ 75°F (24° C)

Storage/Handling: Store indoors, 40°F - 90°F (4°C - 32°C)