MSDS

ManualsBrandsZinsser ManualsPaint5-gal. Bulls Eye Zero White Water Based Interior/Exterior Primer and Sealer

Date Printed: 3/28/2012

Material Safety Data Sheet

24 Hour Assistance:

1-847-367-7700

1. Identification

3/28/2012

Product Name: BEYE 5-GL ZERO INT/EXT WATER BASE Revision Date:

Identification Number:

249021

Product Use/Class: Primer/WB Acrylic

Rust-Oleum Corporation

11 Hawthorn Parkway

Vernon Hills, IL 60061

USA

Rust-Oleum Corporation

11 Hawthorn Parkway

Vernon Hills, IL 60061

USA

Supplier: Manufacturer:

Preparer: Regulatory Department

2. Hazard Identification

EMERGENCY OVERVIEW: Use ventilation necessary to keep exposures below recommended exposure limits, if any.

EFFECTS OF OVEREXPOSURE - EYE CONTACT: Causes eye irritation.

EFFECTS OF OVEREXPOSURE - SKIN CONTACT: Substance may cause slight skin irritation.

EFFECTS OF OVEREXPOSURE - INHALATION: Low hazard for usual industrial handling or commercial handling by trained

personnel.

EFFECTS OF OVEREXPOSURE - INGESTION: Substance may be harmful if swallowed.

EFFECTS OF OVEREXPOSURE - CHRONIC HAZARDS: Contains Titanium Dioxide. Titanium Dioxide is listed as a Group

2B-"Possibly carcinogenic to humans" by IARC. Significant exposure is not anticipated during brush application or drying. Risk of

overexposure depends on duration and level of exposure to dust from repeated sanding of surfaces or spray mist and the actual

concentration of Titanium Dioxide in the formula.

PRIMARY ROUTE(S) OF ENTRY: Eye Contact, Ingestion, Inhalation, Skin Absorption, Skin Contact

3. Composition/Information On Ingredients

Chemical Name CAS-No.

Weight %

Less Than

ACGIH TLV-

TWA

ACGIH TLV-

STEL

OSHA PEL-TWA

OSHA PEL-

CEILING

Titanium Dioxide 13463-67-7 15.0 10 mg/m3 N.E.

15 mg/m3 [Total

Dust]

N.E.

Talc 14807-96-6 5.0 2 mg/m3 N.E.

0.1 mg/m3

(Respirable)

N.E.

Potassium Tripolyphosphate 13845-36-8 0.1

10 mg/m3

(Inhalation, 8Hr)

N.E.

15 mg/m3 (8Hr)

[Total Dust]

N.E.

4. First-aid Measures

FIRST AID - EYE CONTACT: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open. Get medical

attention. Do NOT allow rubbing of eyes or keeping eyes closed.

FIRST AID - SKIN CONTACT: Wash with soap and water. Get medical attention if irritation develops or persists.

FIRST AID - INHALATION: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get

immediate medical attention. Do NOT use mouth-to-mouth resuscitation.

Page 1 / 4

Summary of content (4 pages)

PAGE 1
Date Printed: 3/28/2012 Page 1 / 4 24 Hour Assistance: 1-847-367-7700 Material Safety Data Sheet 1. Identification Product Name: BEYE 5-GL ZERO INT/EXT WATER BASE Identification Number: 249021 Product Use/Class: Primer/WB Acrylic Supplier: Rust-Oleum Corporation 11 Hawthorn Parkway Vernon Hills, IL 60061 USA Preparer: Regulatory Department Revision Date: 3/28/2012 Manufacturer: Rust-Oleum Corporation 11 Hawthorn Parkway Vernon Hills, IL 60061 USA 2.
PAGE 2
Date Printed: 3/28/2012 Page 2 / 4 FIRST AID - INGESTION: Swallowing less than an ounce will not cause significant harm. For larger amounts, do not induce vomiting, but give one or two glasses of water to drink and get medical attention. 5. Fire-fighting Measures Flash Point, °F >200 (Setaflash) EXTINGUISHING MEDIA: Alcohol Foam, Carbon Dioxide, Dry Chemical, Water Fog UNUSUAL FIRE AND EXPLOSION HAZARDS: FLASH POINT IS TESTED TO BE GREATER THAN 200 DEGREES F.
PAGE 3
Date Printed: 3/28/2012 Page 3 / 4 INCOMPATIBILITY: Incompatible with strong oxidizing agents, strong acids and strong alkalies. HAZARDOUS DECOMPOSITION: By open flame, carbon monoxide and carbon dioxide. When heated to decomposition, it emits acrid smoke and irritating fumes. HAZARDOUS POLYMERIZATION: Will not occur under normal conditions. STABILITY: This product is stable under normal storage conditions. 11.
PAGE 4
Date Printed: 3/28/2012 Page 4 / 4 International Regulations: CANADIAN WHMIS: This MSDS has been prepared in compliance with Controlled Product Regulations except for the use of the 16 headings. Canadian WHMIS Class: D2A D2B 16. Other Information HMIS Ratings: Health: 2 Flammability: 0 Physical Hazard: 0 Flammability: 1 Instability 0 NFPA Ratings: Health: 2 VOLATILE ORGANIC COMPOUNDS, g/L: REASON FOR REVISION: 1 No Information Legend: N.A. - Not Applicable, N.E. - Not Established, N.D.