MSDS

ManualsBrandsZinsser ManualsPaint1-gal. DIF Gel Wallpaper Stripper (4-Pack)

Material Safety Data Sheet

N/A: Not Applicable N/D: Not Determined N/E: Not Established N/R: Not Required Est.: Estimated

DIF Gel MSDS (12-01-06) Page 1 of 6 pages.

Section 1 General Information

Manufacturer:

Zinsser Company, Inc.

173 Belmont Drive

Somerset, NJ 08875

(732) 469-8100

Emergency Telephone: Chemtrec (800) 424-9300 Date: December 1, 2006

Product Name: DIF Gel

Codes: 02431 02435 02436 02451

Section 2 Hazardous Ingredients

OSHA ACGIH

Hazardous Component CAS# PEL TLV

None.

Section 3 Hazard Identification

Emergency Overview: This material is a translucent blue gel with a mild odor. This

material is not flammable and has a flashpoint above 200° F.

Primary Routes of Exposure:

Skin Contact

Eye Contact

Potential Acute Health Effects:

Eye: May cause eye irritation.

Skin: Prolonged or repeated skin contact may cause irritation.

Ingestion: Not hazardous under intended use conditions.

Inhalation: Not hazardous under intended use conditions.

Potential Chronic Health Effects: None known.

(See also Sections 4, 8, and 11 for related information)

Summary of content (6 pages)

PAGE 1
Material Safety Data Sheet Section 1 General Information Manufacturer: Zinsser Company, Inc. 173 Belmont Drive Somerset, NJ 08875 (732) 469-8100 Emergency Telephone: Chemtrec (800) 424-9300 Product Name: Codes: Date: December 1, 2006 DIF Gel 02431 02435 02436 02451 Section 2 Hazardous Ingredients Hazardous Component CAS# OSHA PEL ACGIH TLV None. Section 3 Emergency Overview: Hazard Identification This material is a translucent blue gel with a mild odor.
PAGE 2
Section 4 First Aid Measures Eye contact: Flush eyes with water for at least 15 minutes. Skin contact: Wash with soap and water. Ingestion: If the person is conscious and able to swallow have them drink water to dilute. Call a poison control center, physician, or emergency room. Inhalation: No specific treatment is necessary since this material is not likely to be hazardous by inhalation.
PAGE 3
Engineering Controls: If necessary, use general room dilution ventilation, process enclosures, local exhaust ventilation, or other engineering controls to control airborne levels below recommended exposure limits. Personal Protective Equipment (PPE): Eye Protection: Eye contact should be avoided. Where eye contact is likely, wear chemical splash goggles and/or full-face shield. Skin Protection: None needed under normally anticipated use conditions.
PAGE 4
Acute Health Effects Sensitization: This material is not considered a sensitizer (as tested in accordance with the FHSA 16 CFR Part 1500.3). Eye Irritation: This material is not considered a primary eye irritant (as tested in accordance with the FHSA 16 CFR 1500.3). Dermal Irritant: This material is not considered a primary dermal irritant (as tested in accordance with the FHSA 16 CFR Part 1500.3).
PAGE 5
The Comprehensive Environmental Response Compensation and Liability Act of 1980 (CERCLA) requires notification to the National Response Center for releases of quantities of Hazardous Substances equal to or greater than the reportable quantities (RQs) in 40 CFR 302.4 (for CERCLA 102). Components present in this product at a level which could require reporting under the statute are: Chemical Name None CAS# N/A Maximum Concentration (Wt.
PAGE 6
Legend: N/A: Not Applicable N/D: Not Determined N/E: Not Established N/R: Not Required STEL: Short Term Exposure Limit C: OSHA Ceiling Value cps: Centipoise mg/m3: milligrams per cubic meter mppcf: million particles per cubic foot of air.