MSDS

ManualsBrandsZinsser ManualsPaint13 oz. B-I-N Shellac-Based White Interior/Spot Exterior Primer and Sealer Spray (6-Pack)

Material Safety Data Sheet

N/A: Not Applicable N/D: Not Determined N/E: Not Established N/R: Not Required Est.: Estimated

Spray BIN MSDS (09-08-08) Page 1 of 6 pages.

Section 1 General Information

Manufacturer: HMIS Rating

Zinsser Company, Inc.

HEALTH:

173 Belmont Drive

FLAMMABILITY:

Somerset, NJ 08875

REACTIVITY:

(732) 469-8100

Emergency Telephone: Chemtrec (800) 424-9300 Date: September 8, 2008

Product Name: Spray B-I-N

Codes: 01008 01009 01010 01040 01099

Section 2 Hazardous Ingredients

OSHA ACGIH

Hazardous Component

CAS#

PEL TLV

Acetone 67-64-1 1000 ppm 500 ppm

n-Butyl Alcohol 71-36-3 50 ppm (skin) 50 ppm (skin)

Ethanol 64-17-5 1000 ppm 1000 ppm

Isopropanol 67-63-0 400 ppm 500 ppm

Kaolin 1332-58-7 15 mg/m

* (5 mg/m

**) 2 Mg/m

Mica 12001-26-2 20 mppcf 3 Mg/m

Propane 74-98-6 1000 ppm 2500 ppm

Sodium Aluminosilicate 1344-00-9 20 mppcf 10 mg/m

* (3 mg/m

**)

Titanium dioxide 13463-67-7 15 Mg/m

* 10 Mg/m

* Total Dust ** Respirable Dust Fraction

Section 3 Hazard Identification

Emergency Overview: This material is an aerosol spray coating used as a primer/sealer.

The aerosol container is pressurized and extremely flammable.

Primary Routes of Exposure:

Inhalation

Skin Contact

Eye Contact

Potential Acute Health Effects:

Eye: May cause eye irritation.

Summary of content (6 pages)

PAGE 1
Material Safety Data Sheet Section 1 General Information Manufacturer: Zinsser Company, Inc.
PAGE 2
Skin: Prolonged contact may cause skin irritation. Ingestion: Although ingestion is not anticipated route of exposure, this material can be harmful if swallowed. It may cause depression of the central nervous system, nausea, and vomiting. Inhalation: irritation. May cause headache, drowsiness, dizziness, nausea, and respiratory tract Potential Chronic Health Effects: None known.
PAGE 3
Section 7 Handling and Storage Handling: Keep away from heat, spark, and flame. Keep operating temperatures below ignition temperatures at all times. Use only in a well-ventilated area. Storage: Store at ambient or lower temperature. Keep containers tightly closed and upright when not in use. Protect against physical damage. Contents under pressure. Do not expose to heat.
PAGE 4
Section 10 Stability and Reactivity Stability: Stable, non-reactive. Hazardous Polymerization: Will not occur. Hazardous Decomposition Products: Conditions to Avoid: None known. Heat, sparks, and open flames. Section 11 Toxicological Information Carcinocenicity: This material is not considered a carcinogen by IARC or NTP and is not regulated as a carcinogen by OSHA. (See also Section 15 for related information) Section 12 Ecological Information Chemical Fate and Effects: No data available.
PAGE 5
Section 15 Regulatory Information CERCLA: The Comprehensive Environmental Response Compensation and Liability Act of 1980 (CERCLA) requires notification to the National Response Center for releases of quantities of Hazardous Substances equal to or greater than the reportable quantities (RQs) in 40 CFR 302.4 (for CERCLA 102). Components present in this product at a level which could require reporting under the statute are: Chemical Name None CAS# N/A Maximum Concentration (Wt.
PAGE 6
Section 16 Other Information Legend: N/A: Not Applicable N/D: Not Determined N/E: Not Established N/R: Not Required STEL: Short Term Exposure Limit C: OSHA Ceiling Value cps: Centipoise mg/m3: milligrams per cubic meter mppcf: million particles per cubic foot of air.