User manual

Ethernet Smart Cable
User Manual
UM020705-1012 Page 9 of 13
cable’s IP address, which can be obtained from ZDS II in the ZDS II Project Settings win-
dow; see Steps 5 through 9
on page 4).
Observe the following steps to change the Ethernet Smart Cable’s default settings:
1. Obtain the Ethernet Smart Cable IP address.
2. Open your web browser to the IP address located in Step 1. The Ethernet Smart Cable
home page will appear, as shown in Figure 6. The
Settings tab on this page provides
access to the Ethernet Smart Cable’s network settings. The
Password tab, shown in
Figure 7, allows you to set a password for Ethernet Smart Cable access.
Figure 6. Ethernet Smart Cable Home Web Page