User manual

Z8 Encore! XP
®
Development Kits
Quick Start Guide
Getting Started Using ZDS II QS004303-0205
Page 8
11. The three LEDs on the development board begin blinking in sequence. If the LEDs do
not blink, start over from Step 3 on page 5.
(Z8F04A08100KIT development kits only) LED D2/PA0 is shared with the
DBG pin when the board is in debug mode. The LED will therefore not be
fully illuminated.
12. Press the
TEST pushbutton to change the sequence of the LEDs to blink in the oppo-
site direction.
For more information about using ZDS II and building projects for your
Z8 Encore!
®
development kit, refer to the ZiLOG Developer Studio II–
Z8 Encore!
®
User Manual
(UM0130).
Note: