User manual

Z8 Encore! XP
®
Development Kits
Quick Start Guide
Page 3
QS004303-0205 Setting up the Development Board
this kit, refer to the Z8F04A08100KIT Z8 Encore! XP™ 4K Series User Manual,
UM0187.
Steps 3 and 4 below refer to installing the serial Z8 Encore! Smart Cable. For
instructions on installing the Z8 Encore! USB Smart Cable, refer to the USB
Smart Cable User Manual, UM0181, on the CD-ROM included with the
development kit.
Do not connect the power supply to the development board before con-
necting a Z8 Encore! Smart Cable to both the host PC and development
board.
3. Connect the serial port of the PC to the
Z8 Encore! Smart Cable DB-9 female connec-
tor.
4. Connect the
Z8 Encore! Smart Cable to development board pin header P2.
5. Connect the power supply to the development board at J1, then to an electrical outlet
(Figure 1 on page 4).
Connecting the Power Supply
The universal power supply kit features four different plug adapters in one box and the
power supply itself in another. The power supply ships with a slide-out plate that must be
removed to insert the location-specific plug adapter.
1. Remove the slide-out plate.
2. Select the AC plug adapter appropriate for your locale and insert it into the slot that
remains after removing the slide-out plate.
3. Slide the new plug adapter into the slot until it snaps into place.
4. Plug the power supply into an electrical outlet.
Note:
Caution: