Service manual

March 2009 TTPM3 - Service Manual 37
5.4.3 Adjusting output solenoid
No ticket should be inserted!
1) Loosen the two screws holding the solenoid coil
2) Press and hold down the plunger
3) Move the coil towards the plunger using the screwdriver, and tighten the screw.
Press down
on plunger
Adjus
t
Lift with
screwdriver
and tighten
Press down
on plunger
Pull / push to check
that ticket is held by roller
Verify
5.4.4 Verifying adjustment of output solenoids
1) Insert a ticket in the entry you want to check
2) Press on the plunger for that entry and verify that the ticket is hard to pull/push.
Release the plunger and check that the ticket moves freely.
5.4.5 Adjusting waste basket solenoid
1) Loosen the two screws holding the solenoid coil
2) Press up and hold the plunger
3) Allow the coil to fall down towards the plunger, and tighten the screw.
Press plunger up
Press down with
screwdriver and tighten