Service manual

34 TTPM3 - Service Manual March 2009
5.2.2 Front
TTPM3 without front load option
1. Loosen 1.5-mm hexagonal (Allen) screws J and K keeping the front ticket guide plate
in position. Widen the ticket path by pushing the loose guide plate toward the right
hand side of the TTPM3.
2. Insert the gauge under plastic leaf spring L and feed the gauge up to the front of feed
rollers M. Do not insert the gauge between the rollers.
3. Verify that the gauge, in all its length, is in touch with the fixed guide plate on the left-
hand side.
4. Keep the front guide plate pressed gently against the gauge while tightening screws J
and K.
5. Remove the gauge.
TTPM3 with front load option installed
The adjustment procedure is almost the same as when no front load option is installed.
The only difference is that gauge N should not be inserted through the front load input
module. Instead, position the gauge on top of the input module and push the gauge in
between plastic leaf spring L and the rubber belts.
Figure 18. Adjusting the front ticket path on a printer with front load
5.2.3 Completion
1. Keep the printhead engagement arm pulled forward while mounting the printhead
module in reverse order. Ensure that the extended, fork-shaped part of the printhead
module engages with the arm. Secure the rod with the enclosed new circlips.
2. Connect the ribbon cable at the top of the printhead module.
3. Close the lid (optional).
4. Switch ON the power.