Service manual

March 2009 TTPM3 - Service Manual 33
5.2.1 Rear
1. Loosen 1.5-mm Allen-screws G and H keeping the rear ticket guide plate in position.
Widen the ticket path by pushing the loose guide plate toward the right hand side of
the TTPM3.
Figure 17. Adjusting the rear ticket path
2. Insert the gauge through the rear lower ticket entrance, and feed the gauge all the
way up to the cutter.
CAUTION! — The gauge must not be inserted through the rear upper ticket
entrance since this may damage the gauge. The upper entrance does not need to be
checked or adjusted separately.
3. Verify that the gauge, in all its length, is in touch with the fixed guide plate on the left-
hand side.
4. Keep the rear movable guide plate gently pressed against the gauge while tightening
hexagonal screws G and H.
5. Remove the gauge by turning the rearmost cogwheel.