Service manual

March 2009 TTPM3 - Service Manual 29
4.4.10 Control board
When you order a control board as replacement parts it is configured with firmware and
parameter settings suitable for the factory.
REMOVAL
1. Remove the printer/encoder unit from the cabinet as described above.
2. Disconnect all cables from the board, and mark them with a permanent marker
pen to ease reconnection.
3. Remove the big hexagonal spacers (nuts) and remove the board.
REPLACEMENT
1. Fit the board in the reverse order.
2. Load the firmware that the customer is using into the printer.
3. Set up the parameters according to the customer’s specification.
Instructions how to load firmware and set parameters is available in the Technical
Manual.