Service manual

28 TTPM3 - Service Manual March 2009
4.4.8 Magnetic stripe module
REMOVAL
1. Remove the printer/encoder unit from the cabinet as described above.
2. Remove the input module as described above.
3. Disconnect the two cables from the control board connector J3.
4. Remove the four screws securing the magnetic stripe module.
5. Remove the magnetic stripe module. Save the two plastic spacers located un-
der the magnetic stripe module.
REPLACEMENT
Mount the module in the reverse order. Push the module towards the cutter to get it
straight, and then tighten the screws.
4.4.9 Cutter module
REMOVAL
1. Remove the printer/encoder unit from the cabinet.
2. Remove the input module and the magnetic stripe module as described above.
3. Remove the printhead module.
4. Remove the output module.
5. Remove the four screws holding the cutter module in position. The screws (two
screws on each side) are located below the big holes in the side plates of the
basic module.
6. Disconnect the cable from the control board connector then mark the
housing with “J21” so it is easy to reconnect.
7. The shaft of the cutter motor extends so far that you have to press the
side plates of the basic module slightly apart while you remove the
cutter module.
REPLACEMENT
Fit the cutter module in the reverse order.
WARNING!
DANGER OF INJURY. Depending on the position of the carrier wheel on the cutter
module, the cutting mechanism may start moving when the mains power supply is
switched ON. KEEP HANDS AWAY WHEN SWITCHING ON THE POWER.