Users Manual

ACTIVATINGRF

The flowchart below shows different setup methods that will be supported by the RCU implementation on
the STB:


Figure1–Quicksetflowchart
ThefollowingaredescriptionsoftheQuicksetfeatures:

KeyCodesDownload‐ThisfeaturewilldownloadasetofIRcodestotheremote.

CodeTest–thisfeatureallowstheusertotestandseewhetheraselectedcode‐setwillworkwitha
specificdevicepriortoassigningit
toamodeontheremote.Note:Thisfeatureisnotplannedtobe
implementedontheSTB.

Auto Setup – The Quickset library in UAPI provides a feature of automated lookup by identifying the
attached devices by means of HDMI-EDID look-up or using CEC control information. Automated lookup
will allow the programming of devices that support EDID/CEC information automatically without going
through the standard device-brand-model lookup route. CEC/EDID information of connected device is
obtained and passed to respective API. Based on the information passed, API will retrieve code sets for the
device connected which can be used for programming the remote.

Manual Setup – Manual setup assists the user with a UI flow and enables to setup RCU manually. The user
is instructed to search for brand/model of his device, and the programming sequence is displayed with the
correct ID to the user.
