User manual

! !!
!
8"
ZIG&POE&RXAV"USER"MANUAL!
!
Panel Description
Right Side Panel
1. Speaker connection – 4 pin female locking connector. Connect directly to
speaker wires and then to speakers. Output is 20 watts per channel –
plenty or sound for classroom, bedroom, conference room or huddle room.
2. Dip Switch –
Dip Switch Settings:
Default/Factory – All Up or OFF
Up = Off
Down = On
DIP 1: EDID
OFF: EDID default mode (use EDID from connected TV)
ON: Custom EDID - not implemented yet. Once implemented will override
switches 2 and 3.
DIP2: Force 3D Off
OFF: EDID copied from HDMI output
ON: EDID copied but force output to NO 3D
DIP3: Force 2 Channel Audio
OFF: EDID copied normal with multichannel audio
ON: EDID forced 2 channel stereo
DIP4: Audio Routing
OFF: Speaker output (amp turned on)
ON: HDMI output to TV (amp turned off)
3. HDMI Output – Connect HDMI cable here for output to the display or
projector.
4. RS-232 – Connect to standard 9 pin serial port and on to your projector,
TV, 3
rd
party controller, etc for RS-232 device control