User manual

! !!
!
20"
ZIG&POE&RXAV"USER"MANUAL!
!
Command Structure:
ZIG-POE-RXAV RS232 commands
<@hostname> <sp> <command> <sp> <parameter> <end of command>
<@hostname > indicates the specific target RXAV device, preceded by @ <sp>
whitespace, space or tab <command> defines the current operation <parameter>
is the variable or the value passed to the device
<end of command> newline char \n, ASCII 0xA [hex]
Response Structure:
<@hostname> <sp> <parameter> <sp>... <parameter> <sp> <end of
response>
<@hostname> = indicates the device initiating the response <sp> = space, ASCII
0x20 <parameter> = command-specific number of parameters, each followed by
a space 0x20 [hex] <end of response> = newline char \n, ASCII 0xA [hex]
RS232 Protocol Settings:
Baud Rate = 115200 Data Bits = 8 Parity = None Stop Bit = 1
Flow control = None
ZIG-POE-RXAV COMMANDS:
Set volume [range -136dB to +10dB, 1dB steps]
@rxav-01 vol -25
Set device ‘rxav-01’ volume to -25dB Response: @rxav-01 vol x
Increase volume
@rxav-01 volup
Increase device ‘rxav-01’ volume by 1dB Response: @rxav-01 vol x
Decrease volume