User Manual

Zigbee WIFI Radiator Actuator User Manual
Many thanks for your selection of our products and services, and also for your trust and support
to us.
Search for "Smart RM" or “Smart Life” Download
the Wifi App with the following icon
Note:Cellphone and gateway must connect
under the same WIFI router.
Add your gateway to the App,then add your
radiator actuator to your gateway in the App.
After the actuator has completed self-test, long
press
access to interface,short press
to
choose
icon,short press to confirm this
option,long press
, flashing to add
thermostat to APP.
Product Specifications
Power: 2* AA alkaline batteries Insulating condition: Normal environment
Display accuracy:
：
0.5
℃
Running program: Set per 1 week as a cycle
Probe sensor:：NTC(10k)1% Size(mm)：53*89.5mm
Maximum route：4.5mm Range of temperature display:：1~70°C
Default range of temperature adjustment：5~35°C Maximum current：90mA
Working environment temperature:
：
-10~60°C Thread size
：
M30*1.5
Displays & Buttons
No.
Icon
A
Weekly programmable icon; Low battery; Children lock;
Open Window function
B
Holiday mode; Auto mode; Boost mode;
WIFI connection status
C
Time setting interface: hours setting; minutes setting
No.
keys
Represent
D
1.Short press to switch manual mode and auto mode
2.Long press to access setting interface
3.Confirm key
E
1.Decrease key
2.Long press to lock/unlock keys
F
1.Increase Key
2.Long press access Boost function setting
Installation and initial commissioning
Install the actuator with the valve and
power-on , all of the icons appear, 3s later
display program version NO.
Time setting: flashing,press display hour setting,press or to adjust value,press again
display minutes setting,press or to adjust value,press again to set week,press or
to adjust value,press to confirm setting and remember time.
Note:after actuator self-testing,under normal working status,if need to modify time,please choose
and press access to setting.the same as above method(it will the same as network time after
wifi connection)
Continuous click until “Ad” appear, press again, actuator begin self-testing, self-testing is finished,
working interface appear
Malfunction
Error Code
Description
E1
Motor fault
E2
Sensor fault
Flashing show low battery
Connect wifi display this icon, disconnected wifi will disappear
Note: After malfunction is solvedpress to self-testing again to self-test again
Function description
Holiday mode:press 3s access to setting interface, press or until flashing ,then press
to confirm and enter temperature setting, press or to adjust value
，
press confirm and enter
days setting, press
or to adjust value. If you want to cancel holiday mode, press to choose
manual or auto mode then exit.
Ventilation and energy saving:ventilation and energy saving function is default off, if you want to
open this function, please set in advanced options(The default settings will be restored when the
battery is replaced )