Instruction Manual

10. Find and Unbind a Zigbee Lighting Device
11. Clear All Find and Bind Mode Paired Lighting Devices
12. Setup a Network & Add Devices to the Network (No Coordinator or Hub Required)
Step 5: Add more remotes to the network as you would like.
Step 6: Factory reset the lighting devices that you would like to add to the network, refer to their manuals.
Step 7: Touchlink to pair the added remotes and lighting devices you would like to add, the devices will be added
to the network through Touchlink, refer to their manuals.
14. How to Check Whether the Remote Belongs to a Network or not
Short press any button, indicator blinking means the remote has already been added to a network. No blinking of
indicator means the remote does not belong to any network.
LED indicator
Step 1: Start find and bind mode on
the Zigbee lighting device (initiator
node) and enable it to find and bind
target, refer to its manual.
ZigBee Lighting Device
Step 2: Press and hold down both
until LED indicator turns on.
Step 3: Short press twice to enable the
remote (target node) to find and unbind
initiator. LED indicator flashes 4 times
for successful unbinding or twice if
unbinding fails.
LED indicator
Step 1: Press and hold down both
until LED indicator turns on.
Step 2: Short press 5 times
continuously to clear all bound lighting
devices . LED indicator flashes 4
times for successful unbinding.
LED indicator
Step 1: Factory reset the remote and
the lighting device, refer to their
manuals.
ZigBee Lighting Device
< 10cm
Step 2: TouchLink the remote and
device to setup a network, refer to
their manuals.
Step 3: Short press button to enable
the network to discover and add
devices, LED indicator will flash
twice. 180 seconds timeout, repeat
the operation.
Step 4: Set another remote into
network pairing mode and pair it to the
network, refer to its manual.
13. OTA
The remote supports firmware updating through OTA, and will acquire new firmware from zigbee controller or
hub every 10 minutes automatically.
15. Battery Power Monitor Function
The remote will report battery power value to the coordinator under following situations:
• When powered on.
• When short pressing both and buttons simultaneously.
• When operating the switch to send data packets (over 4 hours since last operation).
• When added to the network by a coordinator.
Mounting
The key part of this controller is an universal one, especially rotary standard switch element that can be integrated in
numerous frames by different manufactures as below list:
BEKER S1, B1, B3, B7 glass
GIRA Standard55, E2, Event, Esprit
JUNG A500, Aplus
MERTEN M-smart, M-Arc, M-Plan
2.Install the controller to wall(2 methods)
Method 1:Stick 3M glue on the
back of the bracket and then stick
the bracket to the wall
Method 2:Screw the bracket
to the wall
After the bracket is fixed,clip
the frame and control part to the
bracket in sequence
①
silicone gel battery cover
Use tool to open the
1.Remove battery insulator
②Pull out the
battery insulator
③Install the silicone
battery cover back
Installation
Importer:
Namron AS
Nedre kalbakkvei 88B
1081 Olso
Norway
Made in China