User Manual

Zigbee 4 In 1 Multi Sensor
Function introduction
Important: Read All Instructions Prior to Installation
Product Data
Physical Information
Dimensions
Material / Color
55.5*55.5*23.7mm
ABS / White
Electrical Information
Operate Voltage
Standby Consumption
3VDC (2*AAA Batteries)
10uA
Wireless Communication
Radio Frequency
Wireless Protocol
Wireless Range
Radio Certification
2.4 GHz
Zigbee 3.0
100 feet (30m) Line of Sight
CE
Sensing
Humidity Range and Precision
Motion Sensor Type
Recommended Installation Height
Illuminance Measuring Range
Temperature Range and Precision
PIR sensor Detection Range
PIR sensor
Max. 7 meters
Wall mount, 2.4 meters
-40°C~+125°C, ±0.1°C
0 – 100% RH (non-condensing), ±3%
0~10000 lux
Environment
Operating Temperature Range
Operating Humidity
Waterproof Rating
Safety Certification
32℉ to 104℉ / 0℃ to 40℃ (indoor use only)
0-95% (non condensing)
IP20
CE
Product Description
The Zigbee sensor is a battery powered low power consumption 4 in 1 device that combines PIR motion sensor,
temperature sensor, humidity sensor, and illuminance sensor. The PIR motion sensor trigger and sensitivity can be
configured. The sensor supports low battery power alarm, if the power is lower than 5%, the motion sensor trigger and
report will be forbidden, and the alarm will be reported every one hour until the battery power is higher than 5%. The
sensor is suitable for smart home applications which need sensor based automation.
Commissioning
All setup is performed via supported IEEE 802.15.4-based control platforms and other Zigbee3.0 compatible lighting
control systems. Appropriate gateway control software allows for adjustment of motion sensitivity, detection area, time
delay and daylight threshold.
• Autonomous sensor-based control
• Humidity sensing, automates your home humidifying or dehumidifying
• OTA firmware upgrade
• Wall mount installation
• PIR motion sensor, long detection range
• Temperature sensing, automates your home heating or cooling
• Can be use for indoor applications
• Illuminance measuring, daylight harvesting
• Zigbee 3.0 compliant
Key Features
• Compatible with universal Zigbee platforms that support sensor
• Cost-effective solution for energy savings
• Robust mesh network
• Energy code compliance
Benefits
• Smart home
Applications
PIR sensor
Daylight sensor
Front Side Back Side
55.5mm
55.5mm
18.5mm
23.7mm
Battery compartment cover, remove the cover,
you can see Prog. button & LED indicator
inside. Before the first use, please remove the
insulator film
LED Indicator Status
OTA firmware update
Identify
Joining a network (Triple press the button)
Joined successfully
Leaving a network or reset (Long press the button)
Already in a network (Short press the button)
Not in any network (Short press the button)
Operation Description
PIR motion sensor triggered
Powered on
LED Status
Flashing once rapidly
Staying solid on for 1 second
Flashing twice rapidly with 1 second interval
Flashing slowly (0.5S)
Flashing rapidly continuously
Staying solid on for 3 seconds
Flashing slowly (0.5S)
Staying solid on for 3 seconds
Flashing three times slowly (0.5S)
Revised 05.20.2022