Technical data

TR440 12310-0702-04 Seite
18
/ 24 www.ziehl.de
8.17 Code block
Here, the set parameters can be protected by activating a code block. The device acknowledges an incorrect
entry with 8Err8 (flashes three times). Select the menu item with the Up/Down key until …
 Display 8Cod.8
 Press the Set key
 Display 8Pin.8 / 8 0.8 (pin / pin code) flash alternately
 Use the Up and Down keys to set the saved pin code (factory setting is 8504.8)
 Press the Set key
 Set the desired code block using the Up and Down keys:
o 8off.8 off, all parameters can be changed
o 8on .8 on, no parameter can be changed
 Press the Set key
 Display 8Pin.8 / 8 504.8 (pin / pin code) flash alternately
 Set the desired new pin code with the Up and Down keys (caution: write down the pin
code)
 Press the Set key
 Code block on, Display 8on 8 flashes three times
 Code block off, Display 8off8 flashes three times
 Exit the menu item (display 8Cod.8)
 Use the Up key to go to the previous menu item
 Exit the menu mode with the Down key and return to the display mode
(normal state).
8.18 Tips on operating
 When the right-hand decimal point in the 7-segment display is illuminated, one has exited the display
mode and can use Up/Down to select the individual menu points (menu mode).
 When the right-hand decimal point is flashing, one is in the configuration mode and can change the
settings with Up/Down.
 In the configuration mode:
o Pressing Up/Down for a long time accelerates the changes in the display.
o Pressing the Up and Down keys simultaneously changes the set values to zero.
 With reset (press Set/Reset for 2 s), one returns from any position in the configuration mode or menu
mode (exception: in the simulation mode there is a locked alarm -> Alarm is reset) back into the display
mode (most recently set values are taken on during this).
 Activate simulation mode (in display mode):
o EasySimulation, press Up and Down keys simultaneously ≥ 2s