User's Manual

13
Step 3 Type the "Access Point MAC Address" from the label on the bottom of the
Access Point, type the “Config IP” address from your system administrator, and
then click “
OK
”.
Step 3 Open a MS-DOS Prompt window and type
ping
followed by the IP address
used in the IP Config. The IP address is assigned to the Access Point . The
Access Point’s replies to the ping confirm that the IP address was assigned
correctly.
Step 4 If you get a ping reply, then the IP address has been temporarily set. In
order to set it permanently you need to run SNMP Manager without powering off
the Access Point.