User's Manual

BIOS Setup
Page 29 Mainboard User's Manual
AC97 Modem
Default setting is "Auto", BIOS will automatically detect onboard AC97
Modem.
IDE HDD Block Mode
Enabled / Disabled IDE HDD Block Mode. Default setting is "Enabled".
Power On Function
Specifies the keyboard hot key, mouse button, power button to wakeup the
computer from S
3
-S
5
state. Available options are Button only: Password,
Hot key, Mouse left, Mouse right, Any key, keyboard 98. Default setting is
Button only.
KB Power On Password
Sets Keyboard Power on Password.
Hot Key Power On
Sets power on Hot key. Default setting is "Ctrl-F1".
On-board FDC Controller
Enabled / Disabled on-board FDC controller. Default setting is "Enabled".
Onboard Serial Port 1 & 2
Specify the I/O port addresses of serial port 1 and 2. Available settings are
Auto, Disabled, 3F8h, 2F8h, 3E8h and 2E8h. Default setting is "Auto".
UART Mode Select
Specifies the operation mode of onboard Serial Port 2. The onboard Serial Port
2 can be configured as an Infrared(IR) port or an ordinary RS-232 serial port.
Available settings are Normal, IrDA and ASKIR. Default is "Normal".
UR2 Duplex Mode
This option is not available when UART is set to "Normal". Available options
are Half Duplex and Full Duplex. Default setting is "Half Duplex".
Onboard Parallel Port
Specifies the I/O port address of the onboard parallel port. Available settings
are Auto, Disable, 378h, 278h and 3BCh. Default is "Auto".
Parallel Port Mode
Specifies the onboard parallel port mode. Available options are Normal, Bi-Dir,
ECP and EPP. Default is "ECP".